1–3
Warnings
WARNING
FIRE, EXPLOSION, AND ELECTRIC SHOCK HAZARD
Improper grounding, poor air ventilation, open flames, or sparks can cause a hazardous condition and
result in fire or explosion and serious injury.
The PrecisionMix Controller must only be installed and serviced by a qualified electrician.
The PrecisionMix Controller is for use only in non-hazardous locations. The maximum applied relay
voltage shall not 24 volts. Do not operate the controller in hazardous locations, as defined
in Article 500 of the National Electrical Code (USA).
Ground the equipment and the object being sprayed. See
Ground the System
on page 3–30.
Do not install non-intrinsically safe equipment in a hazardous area.
Provide fresh air ventilation to avoid the buildup of flammable vapors from solvent or the fluid being
sprayed.
Extinguish all the open flames or pilot lights in the spray area.
Keep the spray area free of debris, including solvent, rags, and gasoline.
Do not turn on or off any light switch in the spray area while operating or if fumes are present.
Do not smoke in the spray area.
Do not operate a gasoline engine in the spray area.
If there is any static sparking while using the equipment,
stop spraying immediately
. Identify and
correct the problem.
Keep liquids away from the electrical components.
Disconnect electrical power at the main switch before servicing the equipment.
The battery inside the PrecisionMix Controller may explode if mishandled. Do not recharge or
disassemble the battery. Do not expose the battery to fire or heat. The battery is intended for use
at normal temperatures, where high temperature cycles are not expected to exceed 212
F
(100
C).
TOXIC FLUID HAZARD
Hazardous fluids or toxic fumes can cause serious injury or death if splashed in the eyes or on the
skin, swallowed, or inhaled.
Know the specific hazards of the fluid you are using. Read the fluid manufacturer’s warnings.
Store hazardous fluid in an approved container. Dispose of hazardous fluid according to all local,
state and national guidelines.
Wear the appropriate protective clothing, gloves, eyewear, and respirator.
Summary of Contents for PrecisionMix ii
