Graco PrecisionMix ii, Instructions And Parts List

Page: 84 / 260

Operation 4–18
Printer Reports
The PrecisionMix II 3K can output reports to a printer
that is connected to the controller. The report will show
the PrecisionMix II 3K information available at the time
the report was printed.
In order to send reports to a printer, the printer option
had to be selected during system configuration. You
can also choose to automatically generate a run report
when a color change is initiated. Refer to
System
Configuration , page 8–14.
Print Setup Screen
SYSTEM CONFIGURATION Station: 1
PRINT SETUP
Select the reporting type:
1. Network (Printer Disabled)
2. Printer Enabled
> 2
Select whether or not a Color Change will
automatically generate a run report.
1. No
2. Yes
> 2
To output the report you desire, you need to be at the
mode of operation for the desired report when you
press the print key on the User Interface. See the
description of the following individual reports for more
information. The printer will print reports that are
similar to the reports shown, only they will show the
values on your system.
Pressing the print button on the Operator Station will
always print the Run Mode Report. See Fig. 4.8.
Fig. 4.8
Print Button
Operator Station
without Color Change Control
Run Mode Report
To print the Run Mode Report with the User Interface,
you must be at one of the run mode screens, then
press the print key. Pressing the print button on
the Operator Station will always print the Run Mode
Report.
The Run Mode Report will list the information that can
be accessed on the Run Mode screens. The values
will show what the PrecisionMix II 3K is producing at
the time the report was printed.
The printer will print a report that is similar to the report
below. An alarm report will print each time a run report
is requested. The alarm history is then cleared.
Run Report
GRACO PMIX II 3K RUN REPORT
Station 1 0/00/00 00:00
Active Recipe 1
Target Volume A = 48.0 cc
Target Volume B = 16.0 cc
Target Volume C = 16.0 cc
Desired Ratio A:B = 3.00:1
Desired Ratio C:B = 1.00:1
Current Ratio A:B = 3.00:1
Current Ratio C:B = 1.00:1
Gun 1 Flow Rate Setpoint = 0500 cc/m
Gun 2 Flow Rate Setpoint = 0500 cc/m
Job Total A = 026637 cc
Job Total B = 008879 cc
Job Total C = 008879 cc
Job Total A+B+C = 044395 cc
** Job totals were reset **
Batch Total A = 2663.7 L
Batch Total B = 0887.9 L
Batch Total C = 0887.9 L
Batch Total A+B+C = 4439.5 L
Batch Total Dump A+B+C = 0000.0 L
** End Run Report