GE Voluson i BT06, Service Manual

Page: 153 / 516

GE V
OLUSON
i / V
OLUSON
e
D
IRECTION
KTI106052, R
EVISION
10 S
ERVICE
M
ANUAL
Chapter 3 - Setup Instructions 3-83
3-7-2 Installing Digital Color Printer Sony UP-D23MD or UP-D25MD
1.) Power off/Shutdown the system as described in: Section 3-6-3 on page 3-72 .
2.) Connect the printer as described on page 3-52 .
NOTE: “Mouse functions” can be performed by using the trackball for moving the cursor.
“Normal select” (Click) = left/right trackball key; “Opening a context menu” = upper trackball key
3.) Turn ON the printer, then switch ON the power of the system and wait till the system has booted.
NOTE: The power switch of the printer has to be in ON position before starting the system!
3-7-2-1 Install the UP-D23MD/UP-D25MD printer software/driver
Perform the following steps if this printer was never installed on the Voluson i / Voluson e!
1.) Connect the USB cable to the printer and the system. The windows ‘Searching for Drivers …’,
‘Found new Hardware …’ and finally the following windows appear.
2.) Select “No, not this time” and verify with NEXT.
3.) In the next window, select “Install from a list or specific location!" and then click on NEXT.
4.) Select “Search for the best driver in these locations” and check mark “Include this location in the
search” (see: Figure 3-101 on page 3-84 ).
NOTICE
!! NOTICE:
Do not connect the USB-cable to the printer!
Figure 3-100 Found New Hardware Wizard