GE Voluson i BT06, Service Manual

Page: 140 / 516

GE V
OLUSON
i / V
OLUSON
e
D
IRECTION
KTI106052, R
EVISION
10 S
ERVICE
M
ANUAL
3-70 Section 3-6 - Completing the Set Up
3-6-2 Power On / Boot Up
(cont’d)
NOTE: Through the protection plate near the plug, the power cable can only be plugged in one way.
4.) If not already done, connect peripheral devices such as DVD Drive, etc.
Links to connection schemes can be found in Table 3-9, “Connection Procedures,” on page 3-23 .
5.) Connect the other end of the main power cable to a hospital-grade main power outlet with the
proper rated voltage.
6.) Hold down the
On/Off
button (see: Figure 3-87 ) on the control panel for ~3 seconds.
The system automatically performs an initialization sequence which includes the following:
- Loading the operating system.
- Running a quick diagnostic check of the system.
- Detecting connected probe.
As soon as the software has been loaded, the system enters 2D-Mode with the probe and application
that were used before the system was shut down.
NOTE: Total time used for start-up is typically one minute.
NOTE: When turning on the Voluson i / Voluson e from Standby mode, it takes a few seconds before it
responds.
Do not push the ON/OFF button again during this period. A second push will initiate a full shutdown.
Figure 3-86 main power cable connected to Voluson i / Voluson e
NOTICE
!! NOTICE:
When AC power is applied to the scanner, the
On/Off
button on the control console illuminates amber,
indicating that the System (including the Back-end Processor) is in
Standby
mode.
Figure 3-87 On/Off Button on Control Panel
protection plate
L-shaped circular plug
of main power cable
connected to DC IN
On/Off Button