ViscoSite VL800 Viscometer
Operating Manual
ViscoSite VL800 Viscometer
Galvanic Applied Sciences, Inc.
Email: [email protected]
Phone: (978) 848--2701
Operating Manual Rev: 2.0E
Toll-Free: 1 (866) 252-8470
Page 83 of 132
•
To exit the menu
WITHOUT
saving the most recent
changes, click “
Continue
.”
•
Click “
Cancel
” to remain in the menu. Changes made
are retained on screen but not yet stored to the
transmitter.
Display Units – Configuration/Editing
The Display Units section of the Display Setup screen allows
configuration of the measurement units to be displayed for each
parameter measured or stored by the ViscoSite system. The default
Display Units configuration is shown in Figure 5.14.
Figure 5.14: Default Display Units (Display Configuration)
The measurement parameters have user-selectable measurement units,
with the exception of Density (always expressed as g/cm
3
). The
available units for the other displayed parameters are shown below in
Table 5.2.
Parameter
Available Units for Display
Viscosity
cP x g/cm
3
(Viscosity x Density, default),
cP, mPa s, cSt
Density
g/cm
3
Temperature
°C, °F
Distance
metres, feet
Table 5.2: Available Display Units (Display Configuration)
5.6.2.1 Selecting/Changing the Display Units
•
Click twice on the cell to be edited to display a drop-
down menu of available parameters.
•
Select/left click the desired parameter.
•
Press
ENTER/RETURN
on the keyboard.
•
Make additional parameter selections for the other units
as necessary,
pressing ENTER/RETURN after each
selection
.
•
Once all parameters have been selected in this
submenu as described above,
click on another toolbar
button to trigger the “Save Changes” Dialog.
