ViscoSite VL800 Viscometer
Operating Manual
ViscoSite VL800 Viscometer
Galvanic Applied Sciences, Inc.
Email: [email protected]
Phone: (978) 848--2701
Operating Manual Rev: 2.0E
Toll-Free: 1 (866) 252-8470
Page 91 of 132
the units for the parameter selected in the Display Units portion of
the Display Configuration screen.
The values in the “Units” column are derived from the measurement
units selected in the “Units” s
ection of the Display Setup page (see
Section 5.6.2). They
cannot
be edited from this screen.
5.7.2.1 Selecting and Editing Measurement and/or
Active Relay Condition Parameters
•
Double click on the desired field.
•
Select the desired value from the drop-down menu that
is displayed.
•
Press
ENTER/RETURN
on the keyboard.
•
Make additional parameter entries as necessary,
pressing ENTER/RETURN after each value selected or
entered.
•
Once all parameters have been selected in this
submenu as described above,
click on another toolbar
button to trigger the “Save Changes” Dialog.
•
To
save the most recent changes, click “
Save
.”
This
sends the updated information to the transmitter.
•
To exit the menu without saving the most recent
changes
, click “
Continue
.”
•
To remain in the menu, click “
Cancel
.” The most recent
changes remain on the screen for further editing. They
are not sent to the transmitter.
5.7.2.2 Selecting and Changing Lower and/or Upper
Limit Numerical Values
•
Click on the desired cell.
•
Type in the new value.
•
Press
ENTER/RETURN
on the keyboard.
•
Make additional parameter entries as necessary,
pressing ENTER/RETURN after each value entered.
•
Once all parameters have been configured in this
submenu as described above,
click on another toolbar
button to trigger the “Save Changes” Dialog.
•
To save the most recent changes, click “
Save
.”
This
sends the updated information to the transmitter.
•
To exit the menu without saving the most recent
changes
, click “
Continue
.”
•
To remain in the menu, click “
Cancel
.” The most recent
changes remain on the screen for further editing. They
are not sent to the transmitter.
