ViscoSite VL800 Viscometer
Operating Manual
ViscoSite VL800 Viscometer
Galvanic Applied Sciences, Inc.
Email: [email protected]
Phone: (978) 848--2701
Operating Manual Rev: 2.0E
Toll-Free: 1 (866) 252-8470
Page 65 of 132
•
Press
ENTER
to save the edited value of the selection to
the transmitter.
Pressing
ESC
during analog output configuration editing
when the cursor is at the end of a line aborts parameter
editing without saving changes.
Pressing
ESC
from an Analog Output submenu when NOT
actively editing a parameter returns to the main Output
Configuration menu. Pressing
ESC
again returns to the Data
Display.
The Analog Output configuration may also be performed in
the ViscoSite software
–
refer to Section 5.7.1.
4.5.1.3 Accessing a Digital Relay Output Submenu
With the cursor on the relay output of interest, Press
ENTER
.
The submenu in Figure 4.9 is displayed.
Figure 4.9: Relay Configuration Submenu
Figure 4.9 shows the three parameters that can be edited
for each Digital Relay Output. Table 4.7 indicates the
available selections for these configurable parameters.
