ViscoSite VL800 Viscometer
Operating Manual
ViscoSite VL800 Viscometer
Galvanic Applied Sciences, Inc.
Email: [email protected]
Phone: (978) 848--2701
Operating Manual Rev: 2.0E
Toll-Free: 1 (866) 252-8470
Page 58 of 132
Parameter Meaning
Selectable Values
Primary
(Pri)
The
parameter
configured
to be
primarily
displayed
on a given
LCD line
None (Nothing displayed)
Density
Viscosity (units not yet
specified)
Temp Probe (transducer
sensor tip temperature)
Secondary
(Sec)
The
parameter,
if
configured
,
to be
displayed
on a given
LCD line
when the
up or down
arrow on
the keypad
is pressed.
Temp Dome (transducer
dome block RTD
Temperature)
Temp Elec (Transmitter
internal temperature)
Freq (Oscillation
Frequency of Transducer)
Temp Cp Vis (Temperature
Compensated Viscosity)
Pe and Gain
‡
Table 4.3: Parameters Selectable for Primary and/or
Secondary Display for each Line (1-4) of the Display Setup
submenu
‡
The
“Pe and Gain” selection is for
diagnostic use only.
Please do not configure this parameter for display unless
requested by a Galvanic Applied Sciences Service
Representative.
Alarms Display Submenu
4.4.3.1 Accessing the Alarms Display Submenu
With the cursor on Alarms Display in the Main Display
Submenu, Press
ENTER
.
The Alarms Display submenu in Figure 4.5 is displayed.
