ViscoSite VL800 Viscometer
Operating Manual
ViscoSite VL800 Viscometer
Galvanic Applied Sciences, Inc.
Email: [email protected]
Phone: (978) 848--2701
Operating Manual Rev: 2.0E
Toll-Free: 1 (866) 252-8470
Page 57 of 132
Each line may be configured to:
•
Display a single parameter (Pri=Primary) or
•
Alternate between the display of a primary and
secondary (Sec=Secondary) parameter.
The alternating display behavior on the configured line
takes effect once a secondary parameter choice has been
saved to the transmitter. Alternating display cycle time is
approximately 10 seconds.
Table 4.3 contains the complete list of parameters that can
be configured as Primary and Secondary parameters on the
display.
4.4.2.2 Editing a Main Display Submenu Parameter
using the Keypad
•
From the Main Display Submenu, Use the Up/Down
arrow keys within the submenu to scroll through the
available LCD lines to the line of interest.
•
Press
ENTER
to select the desired <Line number/Pri> or
<Line Number/Sec> entry.
•
Use the Up/Down arrow keys to scroll through the
parameters available for display.
•
Press
ENTER
a second time to save the edited
parameter value to the transmitter.
•
Pressing
ESC
from the Display Units submenu when
NOT actively editing a parameter returns to the main
Display Setup menu. Pressing
ESC
a second time
returns to the Data Display.
Pressing
ESC
during parameter editing when the cursor is
at the end of a line aborts parameter editing
without saving
changes.
The Main Display submenu selections can also be
configured using the ViscoSite software. See Section 5.6.1.
