ViscoSite VL800 Viscometer
Operating Manual
ViscoSite VL800 Viscometer
Galvanic Applied Sciences, Inc.
Email: [email protected]
Phone: (978) 848--2701
Operating Manual Rev: 2.0E
Toll-Free: 1 (866) 252-8470
Page 82 of 132
The Main Display section comprises a four-row table with columns for
selecting the Primary and Secondary Display parameters to be
displayed on the LCD.
The first column, titled “Line” indicates the line
number of the LCD
being configured (1 to 4). The numbers in the cells of this column
cannot be edited.
The second column, “Primary Display,”
includes all parameters (in a
drop-down list) that can be displayed on each line of the LCD as primary
display parameters. The list of available parameters for this column are
shown in Figure 5.13.
The third column, “Secondary Display,”
includes all parameters (in a
drop-down list) that can be displayed on each line of the LCD as
secondary display parameters.
The factory default setup is for no
secondary parameter display.
The available parameters are explained in Table 5.1.
Parameter
Explanation
<Blank>
<Nothing is output on this line>
Viscosity
Present calculated viscosity parameter
Temp Probe Temperature measured by transducer probe (sensor
tip) RTD
Temp Dome Temperature measured by transducer block RTD
Temp Elec
Temperature measured inside transmitter enclosure
Frequency
Present oscillation frequency of the transducer
Temp Comp
Visc
Measured viscosity parameter compensated for
sample temperature
Table 5.1: Parameters Available for Primary and Secondary Display
5.6.1.1 Selecting/Changing Primary and Secondary
Display Parameters
•
Click twice on the desired cell to display a drop-down
list of all parameters that can be displayed on a line of
the LCD as primary or secondary display parameters.
•
Select the desired parameter.
•
Press
ENTER/RETURN
on the keyboard.
•
Make additional parameter selections as necessary,
pressing ENTER/RETURN after each selection
.
•
Once all parameter values have been selected in this
submenu as described above,
click on another toolbar
button to trigger the “Save Changes” Dialog.
•
To save the most recent changes, click “
Save
.”
This
sends the updated information to the transmitter.
