ViscoSite VL800 Viscometer
Operating Manual
ViscoSite VL800 Viscometer
Galvanic Applied Sciences, Inc.
Email: [email protected]
Phone: (978) 848--2701
Operating Manual Rev: 2.0E
Toll-Free: 1 (866) 252-8470
Page 24 of 132
These include, but are not limited to
•
LCD configuration;
•
Analog Output scaling;
•
Digital Relay Configuration.
See Section 4 for a comprehensive guide to configuration and
operation of the transmitter via the front keypad.
System status is indicated by 4 LEDs located above the LCD. Their
functionality is described in Section 4.3.2.
The LCD
’s control electronics
are mounted to the back side of the swing
panel. The LCD and keypad are connected by a grey ribbon cable. A
multicolour ribbon cable connects the LCD control board to the
transmitter’s motherboard
. A potentiometer on the top right corner of
the LCD electronics board adjusts the brightness of the LCD screen. Its
location is denoted by the red circle in Figure 2.5.
Transmitter Motherboard
The ViscoSite
transmitter’s motherboard is
mounted to the chassis
base plate behind the swing panel. If intrinsically Safe (IS) barriers are
required for the application, they are also mounted
and grounded
as
provided to the chassis base plate behind the swing panel. The
motherboard of the ViscoSite transmitter is shown in Figure 2.6.
Figure 2.6: ViscoSite Transmitter Motherboard
