ViscoSite VL800 Viscometer
Operating Manual
ViscoSite VL800 Viscometer
Galvanic Applied Sciences, Inc.
Email: [email protected]
Phone: (978) 848--2701
Operating Manual Rev: 2.0E
Toll-Free: 1 (866) 252-8470
Page 63 of 132
4.4.4.2 Editing a Display Units Submenu
Parameter’s Units using the Keypad
•
Use the Up/Down arrow keys to scroll through the
entries.
•
Press
ENTER
to select the desired parameter.
•
Edit the parameter choice to reflect the desired units for
the parameter.
•
Press
ENTER
to save the edited value of the selection to
the transmitter.
Pressing
ESC
during display units editing when the cursor
is at the end of a line aborts parameter editing without
saving changes.
•
Pressing
ESC
from the Display Units submenu when
NOT actively editing a parameter returns to the main
Display Setup menu. Pressing
ESC
again returns to the
Data Display.
The display units can also be configured using the ViscoSite
software. See Section 5.6.2.
4.5 Output Configuration Menu
Accessing the Output Configuration Menu
•
From the Data Display, press the
Output Config
button on the
keypad.
•
The Output Configuration menu shown in Figure 4.7 is displayed.
This menu is used to configure the operational modes of the three
isolated analog outputs and two digital relay outputs.
Figure 4.7: Output Configuration Menu (Partial)
4.5.1.1 Accessing an Analog Output Configuration
Submenu
With the cursor on the Analog output of interest, Press
ENTER.
The Analog Output submenu in Figure 4.8 is displayed.
