Furuno FV-110, Operator'S Manual

Page: 93 / 240

Configuration with the web interface
5-31
Gateway setup
If the ACU needs to communicate with network units outside the specified sub-nets, you
must specify a default gateway (typically a router).
The default gateway can be set as a static IP address. Then set the default gateway source
to static and enter the IP address of the default gateway. To remove the default gateway
set it to 0.0.0.0.
Alternatively, if your DHCP server is able to provide a default gateway address and you
have selected DHCP client above, then select the same LAN as your default gateway
source.
Zeroconf Settings
On LAN ports 1,3 and 4 you can choose to add a zeroconf address in the network
(169.254.0.0).This zeroconf address will be in addition to the existing static or DHCP IP
address. One port at a time can be enabled.
Zeroconf allows devices to connect to a network automatically.
5.3.5 E-mail setup
To be able to send diagnostics and statistics reports using e-mail you must set up a couple
of parameters. Contact your IT department for the specific data.
To configure the e-mail setup, do the following:
1. Go to SETTINGS > E-mail setup .
Figure 5-25: Web interface: SETTINGS, E-mail setup (example)
2. Enter the data for Outgoing mail server (SMTP), SMTP port number, SMTP
authentication, User name and password. This data is typically provided by your IT
department.
Note
You must set Outgoing mail server to an IP address if DNS has not been set up
in DNS setup in To configure the LAN network on page 5-29.