INSTRUCTION BOOKLET
Y102B-150V
Vertical YAGI ANTENNA
Please Note:
A qualified structural engineer should be
consulted prior to mounting an antenna
on a tower or support structure.
www.tacoantenna.com
30377002 Rev. C
Page 1: ...UCTION BOOKLET Y102B 150V Vertical YAGI ANTENNA Please Note A qualified structural engineer should be consulted prior to mounting an antenna on a tower or support structure www tacoantenna com 30377002 Rev C ...
Page 2: ... fasten the ground wire to RG 213 U cable Run the ground wire along the RG 213 U to a ground rod driven at least 4 feet into the ground 2 Keep the antenna and cable a safe distance from any power lines 2 DOWNLEAD 1 Recommended cable is RG 213 U 2 Thread the connector onto the dipole fitting 3 Use provided S S cable ties to secure the cable to side of the crossarm 4 Lay the cable around the cable m...
Page 3: ...sarm as shown in Figure 2 Use the 1 4 20 x 2 1 4 hex head screws 2 The feedlines connecting the dipoles C and D are attached as shown in Figure 3 using the supplied feedline clamps and the 10 32 x 5 8 long round head screws The feedlines must have a center to center spacing of 3 4 as shown in Figure 3 Attach the feedlines to the top of the feedline clamps There must be bare metal to metal contact ...
Page 4: ...he top is a couple of inches above the crossarm FIGURE 4 CROSSARM HEX HEAD SCREW 3 8 16 UNC X 2 IN 5 72 CM LONG MOUNTING CLAMP MOUNTING CASTING 2 IN 5 08 CM APPROX 3 8 IN 95 CM DIA U BOLTS DIELECTRIC MAST FIGURE 5 CROSSARM BRACE HEX HEAD SCREW 1 4 20 UNC X 2 1 4 5 08 CM LONG BRACE PLATE 5 BRACE ASSEMBLY The crossarm brace is attached to the mast side of the crossarm see Figure 5 using eight 1 4 20...