Furuno FV-110, Operator'S Manual

Page: 211 / 240

List of ADU events
G-7
0A059-0 Antenna
WARNING
Azi cal. limits Azimuth axis calibration result check limits
exceeded. Pointing performance may be
degraded. Info:
0x00000040: End stop detected before expected
limit
0x00000100: Zero width is low 0x00000200:
Zero width is high
0x00000400: Zero slack is high
0x00001000: Friction average is high
0x00002000: Friction peak is high
0x00004000: Friction asymmetry is high Zero
width low/high: Zero reference module
placement may be incorrect. Zero slack high:
Mechanical slack may be too high. Friction
average/peak high: Mechanical friction is higher
than expected. Friction asymmetry high:
Mechanical imbalance may be too high.
0A05A-0 Antenna
WARNING
Xel cal. limits Cross-elevation axis calibration result check
limits exceeded. Pointing performance may be
degraded. Info: See 0A059-0.
0A05B-0 Antenna
WARNING
Ele cal. limits Elevation axis calibration result check limits
exceeded. Pointing performance may be
degraded. Info: See 0A059-0.
0A05C-0 Antenna
WARNING
Pol cal. limits Polarisation axis calibration result check limits
exceeded. Pointing performance may be
degraded. Info: See 0A059-0.
0A05D-0 Antenna
WARNING
ISM warning The ISM has temporarily observed an unusual
situation for temperature or voltage. No user
interaction required. If repeated after cooldown
and reboot, check if the ISM or cables around it
are defective.
0A05E-0 Antenna
WARNING
Low elevation The antenna is not allowed to transmit because
the elevation is too low.
0A05F-0 Antenna
WARNING
Heading range Heading data range error. External heading unit
supplies unreliable data.
0A062-0 Antenna
WARNING
High elevation The antenna cannot perform acquisition in mode
without heading input because the elevation is too
high.
Error code
(ID)
Unit Severity Description Explanation
Table G-1: ADU event messages (Continued)