Furuno FV-110, Operator'S Manual

Page: 150 / 240

OpenAMIP setup for iDirect iNFINITI & Evolution
C-8
The option file must use following information:
Section in the
option file
Requirements
[SATELLITE] The modem provides RX and TX frequency information via a data
connection to the FV-110.
The single-cable solution makes it possible to configure the VSAT
modem to use any LO frequency in the range from 9.6 GHz to 11.3
GHz. The FV-110 will tune to the correct Ku-Band frequency and
provide the correct L-Band frequency to the VSAT modem.
Example: “rx_lcl_osc = 11250.000000”
FV-110 has an extended 8 Watt BUC with LO up conversion
frequency of 12.8 GHz.
— Example: “tx_lcl_osc = 12800.000000”
Note: FV-110 supports any LNB frequency due to the 1-cable design.
[MOBILE]
The iDirect modem must be set to mobile unit and receive the GPS
information from the ACU with the command “w <Valid> <Lat>
<Lon> <Time>”.
Example: “is_mobile = 1”
Tx handshake must not be enabled in the iDirect modem.
Example: “tx_handshake_enabled = 0”
[ODU]
The FV-110 can work either using the Rx or Tx 10 MHz reference
signals provided by the modem or using its own built-in 10 MHz
reference signal. It is recommended to use the Tx 10 MHz reference
signal from the modem. See also
Modem profiles on page 5-22.
Example: “odu_rx_10_mhz = 1”
The FV-110 needs the Tx 10 MHz reference signal in order to allow
TX ON.
Example: “odu_tx_10_mhz = 1”
Table C-5: Information in the VSAT modem option file