Furuno FV-110, Operator'S Manual

Page: 99 / 240

Configuration with the web interface
5-37
To configure the Master ACU
The Master ACU is configured exactly the same way as a stand-alone FV-110 system
with satellite profiles and VSAT modem profiles. Do as follows:
1. Go to SETTINGS > Dual antenna .
2. Select Enable and click Apply .
Figure 5-28: Enabling dual-antenna mode in Master ACU
The FV-110 is now ready to act as Master ACU.
To configure the Slave ACU
The Slave ACU is configured to use the Master ACU as VSAT modem profile. The
VSAT modem profile must point to the IP address of the Master ACU, that is the IP
address of the LAN port at which the Master/Slave communication cable is connected.
1. Add a specific Modem profile for dual-antenna mode, go to SETTINGS > Modem
profiles > New entry .
Figure 5-29: Dual-antenna mode, add Slave modem profile
2. Enter the profile name, for example Dual Antenna Master.
3. As VSAT modem select Dual Antenna Master .
4. IP address: this is the IP address of the LAN connector at the Master ACU. See To
configure the LAN network on page 5-29.
5. Click Apply .
Dual Antenna Master
Dual Antenna Master
10 110 8 74