Furuno Felcom 82, Operator'S Manual

Page: 23 / 230

2. SETTING UP
2-5
The standby display on the terminal unit appears about ten seconds after turning
on the power. After turning on the power, you can begin communications when
the message “Ocean Region registration complete” appears. (The Channel
Status indication should show “SYNC” and the MES Status indication,
“Ready”. )This takes about five minutes.
Date
File Edit Telex Setup WRU HRIS BELL AlmRst Break
Time
Current Satellite
Channel Status
MES Status
Tx
Heading
Antenna Bearing
Antenna Azimuth
Antenna Elevation
Position
NAV DATA
2000-09-08
(00-09-08 15:04)
15:04(UTC)
POR
SYNC
Ready
OFF
270 DEG
209 DEG
119 DEG
30 DEG
LAT 34:00.00N
LON 135:00.00E
NMEA
Tx EIRP Level
Tx RF Level
Rx C/N
Rx IF AGC Level
Rx SYN
Tx SYN
Antenna Status
El AXIS
Az AXIS
Cross EI AXIS
Rx Channel
Tx Channel
000
000
053
154
OK
OK
REMOTE
OK
OK
OK
11292
10000
GYRO DATA OK
Indications shown when
equipment is ready to communicate.
Standby display (terminal unit)
The handset goes into standby about three seconds after the communications
unit is turned on. “Ready” appears when the handset is ready for communications.
When the power is supplied to the handset the display screen changes in the
following sequence.
: Signal strength too low to communicate.
F E L C O M 8 2
I n m a r s a t - B
M o b i l e
T e r m i n a l
( c ) F U R U N O
2 0 0 0 - 0 8 - 2 9
1 2 : 3 4 U T C
I n m a r s a t - B
F E L C O M 8 2
A O R E R e a d y
Ready for
communications
After 3 sec.
Standby display
Signal strength
Start-up display
, , : Communications possible
Standby display (handset)