Furuno Felcom 82, Operator'S Manual

Page: 147 / 230

6. 9.6k DATA COMMUNICATIONS
6-15
Command
O
Q
▲
S
V ▲
X
▲
Z
Description
Causes the MES to go from the on-line command mode to the off-line data mode.
e.g: ATO< CR>
Sets whether a result code is returned.
Q[<n>]
n=0 The MES returns a result code.
n=1 The MES does not return a result code.
•
If <n> is omitted, it is assumed as "0."
•
If the Q1 command is used, no result code is returned for the subsequent com-
mands.
e.g.: ATQ0<CR>
Stores a value in an S register or reads data from it.
For further information, see the section "S Registers."
e.g.: 1. ATS3=13<CR>: Stores "13" in register S3.
2. ATS3?<CR>: Displays the contents of register S3.
Specifies the format for a result code.
V[<n>]
n=0 Displays a result code in the numeric format.
n=1 Displays a result code in the word format.
•
If <n> is omitted, it is assumed as "1."
e.g.: ATV1<CR>
Specifies whether the communication speed (plus BUSY/NO DIALTONE) is displayed.
X[<n>]
Does not display the communication speed (plus BUSY/NO DIA-
LTONE) when a communication is established.
Displays the communication speed (plus BUSY/NO DIALTONE)
when a communication is established.
•
If <n> is omitted, it is assumed as "4."
e.g.: ATX4<CR>
Initializes the command parameters.
The parameters stored in the non-volatile memory are initialized with its initial values.
e.g.: ATZ<CR>
n=0
n=1 - 4