Furuno Felcom 82, Operator'S Manual

Page: 140 / 230

6. 9.6k DATA COMMUNICATIONS
6-8
ATV (ATV1: Word format)
Specifies the format for result codes
ATX (ATX4: Displays the communication speed)
Sets whether the communication speed is displayed at
connection.
AT+WXR (AT+WXR=0: Without extended display)
Chooses the extended display of the CONNECT result
code.
Settings for Inmarsat communications
AT+WLES (AT+WLES=000: Stores LES access codes in memory)
Stores LES access codes in memory and display the
currently stored ones.
AT+WOR (Sea area specified with telephone and facsimile
terminals)
Displays the currently specified sea area and changes it.
AT+WS46 (AT+WS46=11: Uses the Inmarsat system)
Chooses the use of the Inmarsat system.
Note:
The optimal values vary depending on the contents of communications,
remote stations, and the states of lines. Change the settings according to
the states of communications and store the modified values in the non-
volatile memory.
Some communication software can automatically store the settings. If such
software is used, you do not need to store the modified values in the non-
volatile memory.
A sudden failure or a similar event may cause the data in the non-volatile
memory to be lost (if the data is lost, the non-volatile memory is reset to the
values set at the factory). The non-volatile memory is located on the CPU2
circuit board. Therefore, if the circuit board is replaced, your own settings
must be stored again in the memory. For this reason, be sure to write down
the values you have stored in the memory. Your data stored in the non-
volatile memory is not covered by our warranty.