Furuno Felcom 82, Operator'S Manual

Page: 28 / 230

2. SETTING UP
2-10
2.5 Registering the Password at the Handset
There are two handset menu modes: User and Administration. The User mode
provides only a simple menu. The Administration mode requires a password to
open menus. When the system is powered the User mode is in effect.
The password set at the factory is 0000. In this setting you can go into the
Administration mode without a password. To require a password with the
Administration mode enter it as follows:
1. Press [FUNC Quit], [6] and [7] to display the Password input screen.
6 7 P a s s w o r d
O l d :
N e w :
C o n f :
E n t e r : [ E n t ]
Password input screen
2. Key in 0000. Password is shown with asterisks. If you are not using the
factory-set password (0000) enter current password.
3. Press the [ ] key to select the New field.
4. Enter password desired and press the [Ent] key. You may use any four
numerals for the password.
5. Press the [ ] key to select Conf.
6. Enter password again and press the [Ent] key. The message “The password
is changed.” is displayed.
7. Press the [FUNC Quit] key to close the menu. (If the password entered is
invaild the message “Password error!” appears. Enter the password again.)
Store the password in a safe place. To clear the password, enter old password in
the Old field and 0000 in both the New and Conf fields.
Note: Normally the operational mode is the “User mode.” To change to the
Administration mode, do the following:
a) Press [FUNC Quit], [6] and [3] to display the Change Mode input screen.
6 3 C h a n g e M o d e
U s e r
→
A d m i n
E n t e r P a s s w d :
_ _ _ _
E n t e r : [ E n t ]
b) Enter four digit-password and press the [Ent] key. Password entered is
shown with asterisks.