3 Setting up the Network Controller
52
S
etting
up the
Ne
tw
ork
Con
tro
lle
r
3
Select [Network Settings].
1) Select [Ethernet Setting] and then select [Change Settings].
2) Select [TCP/IP - Get IP Address] and then select [Change Settings].
3) Select one from [DHCP], [BOOTP] or [Manual]. If you select anything other than
[Manual], proceed to Step 4.
4) Select [TCP/IP - IP Address] and then select [Change Settings].
Note
•
Enter the IP address in the format “xxx.xxx.xxx.xxx”. The "xxx" should be a numeric value in
the range from 0 to 255. However, the range between 224.XXX.XXX.XXX through
255.XXX.XXX.XXX, and 127.XXX.XXX.XXX cannot be set.
•
When you made an entry mistake, press the <C> (clear) button and enter again.
•
When you move to the next value without entering all 3 digits, select [save/select next].
5) Select [Save].
6) Configure [TCP/IP - Subnet Mask] and [TCP/IP - Gateway Address] as above.
Note
•
Enter the gateway address in the format “xxx.xxx.xxx.xxx”. The "xxx" should be a numeric
value in the range from 0 to 255. However, the range between 224.XXX.XXX.XXX through
255.XXX.XXX.XXX, and 127.XXX.XXX.XXX cannot be set.
