Fuji Electric Monitouch S8 series, Connection Manual

Page: 344 / 406

23.3 Device Connection Setting 23-9
•
n + 7 (ENT2) entry information 2
The entry mode window number where a write operation was executed is written.
The relationship between the window number and base and the window number and overlap is shown in the following
table.
- In case of using the entry mode for the table data display
The line number and the column number will be output to the address n + 1 and the block number to the address
n + 2 of the “Info. Output Memory,” when the bit No. 12 of “Command Memory” in the [Entry] dialog is ON [1]. In only
this case, therefore, the window number cannot be referred because the block number is output to the address n + 7
(ENT2) of the write area.
•
n + 8 (GREPNS) global response
A response is written when a global port number is used in 1 : n communication. The contents of a response are shown
in the following table. For details on the global port number, see page 23-15.
•
n + 9 to n + 15
System reserved
Calendar
Select a device from which the calendar data is read without using the S8 series’ built-in clock. For more information on the
built-in clock, refer to the S8 Series Reference Manual.
•
PLC1 to 2
Calendar data is read from the selected device.
The calendar data will be updated when:
- The power is turned on.
- STOP
→
RUN
- The date changes.
- At the leading edge of a bit (0
→
1) in the calendar memory in the reading area
Initial screen
Set the number of the screen to be displayed when power to the S8 series is turned on.
GD-80 Compatible
This setting is not valid because the GD-80 series cannot be used for universal serial communication.
Window No. Contents
0 Base entry mode
1 Overlap 0 entry mode
2 Overlap 1 entry mode
3 Overlap 2 entry mode
Memory Contents Contents
0000 Global command not received
0100 ACK
Others Identical to NAK code (see page 23-16).