Fuji Electric Monitouch S8 series, Connection Manual

Page: 132 / 406

7.2 Temperature Controller/Servo/Inverter Connection 7-47
*1 Select “Modbud RTU” for the communication protocol on the inverter when connecting with the S8.
*2 When “0” is specified for y98 (bus function) as well as y99 (support link function), the frequency and operation command can be set on
the S8.
When making the frequency and operation command settings on the S8 connected to the connector for the touch panel, specify “3” for
function code H30. When making those settings on the S8 connected to the terminal block on control circuit, specify “8” for function code
H30.
Available Memory
The available memory setting range varies depending on the device. Be sure to set within the range available with the device
to be used. Use [TYPE] when assigning the indirect memory for macro programs.
y99 Support link function 0
H30
Link function
*2
3
Function
Code
Item Setting Example
Frequency Operation Command
0 Function code H30, y98 Function code H30, y98
1 Commanded from the loader Function code H30, y98
2 Function code H30, y98 Commanded from the loader
3 Commanded from the loader Commanded from the loader
Frequency Operation Command
0 Inverter Inverter
1 RS-485 communication Inverter
2 Inverter RS-485 communication
3 RS-485 communication RS-485 communication
4
RS-485 communication
(control circuit)
Inverter
5
RS-485 communication
(control circuit)
RS-485 communication
6 Inverter
RS-485 communication
(control circuit)
7 RS-485 communication
RS-485 communication
(control circuit)
8
RS-485 communication
(control circuit) RS-485 communication
(control circuit)
Memory TYPE Remarks
4 02H