Fuji Electric Monitouch S8 series, Connection Manual

Page: 279 / 406

17-2 17. Yamatake
17.1.1 SDC35/36
Communication Setting
Editor
Communication setting
(Underlined setting: default)
Controller
CPL communication setting
(Underlined setting: default)
Available Memory
The available memory setting range varies depending on the models. Be sure to set within the range available for the device.
Use [TYPE] when assigning the indirect memory for macro programs.
* Addresses 16657 to 31243 are allocated for EEPROM data addresses.
The number of times EEPROM can be reprogrammed is limited (approx. 100000 times). As such, we recommend that
you write such a parameter as to be reprogrammed frequently into RAM, where the number of reprogramming times is
not limited. However, when the parameter has been written into RAM, and the power is turned off and back on, data in
EEPROM is transferred.
For more information, refer to the instruction manual for the controller issued by the manufacturer.
Item Setting Remarks
Connection Mode 1 : 1 / 1 : n / Multi-link2
Signal Level RS-232C / RS-422/485
Baud Rate 4800 / 9600 / 19200 / 38400 bps
Data Length 7 / 8 bits
Stop Bit 1 / 2 bits
Parity None / Odd / Even
Target Port No. 1 to 31
Item (Bank) Indication Setting Remarks
Communication type
(Setup bank)
C64 0: CPL See “20. MODBUS”.
Device address
(Setup bank)
C65 1 to 127 Communication is disabled when “0” is set.
Baud rate
(Setup bank)
C66
0: 4800 bps
1: 9600 bps
2: 19200 bps
3: 38400 bps
Data type: data length
(Setup bank)
C67
0: 7 bits
1: 8 bits
Data type: parity
(Setup bank)
C68
0: Even
1: Odd
2: None
Data type: stop bit
(Setup bank)
C69
0: 1 bit
1: 2 bits
Memory TYPE Remarks
--- 00H