Fuji Electric Monitouch S8 series, Connection Manual

Page: 396 / 406

Appendix 3 n : 1 Connection App3-7
Setting on the Editor
The settings for Multi-link are covered below. The differences with respect to a 1 : 1 connection and the points where care is
required are explained here.
PLC selection
Select the PLC corresponding to the multi-link connection in the [Communication Setting] tab window ([System Setting]
→
[Device Connection Setting]
→
[PLC1]).
Communication Setting
Multi-link
Click the [Setting] button next to [Connection Mode: Multi-link] to display the [Multi-link] dialog, then make the necessary
settings in this dialog.
Connection Mode Multi-link
Local Port No.
1 to 32
*
Specify a port number of the S8 series.
Note that if the port number specified is the same as that already set for another S8 unit, the
system will not operate correctly.
Send Delay Time
0 to 255 msec (Default setting: 20 msec)
Specify a delay time that elapses before S8 sends the next command after receiving data from the
PLC.
Total
2 to 32
*
Set the total number of S8 series, or V series units to be connected in the multi-link connection.
The setting must be the same as other S8 series on the same communication line.
PLC
MONITOUCH
Send delay time “t”