Force Computers MODUSYS 2000 Kernel, Manual

Page: 105 / 114

Removing the Power Supply Unit Replacing Module Unit Components
6-8 ModuSys 2000 Kernel
Removing the Power Supply Unit
This section describes how to remove a power supply unit from the
enclosure.
Danger
Make sure that the mains power supply is disconnected from the module
unit before continuing.
Gefahr
Bitte trennen Sie die Moduleinheit von der Spannungsversorgung, bevor
Sie fortfahren.
Caution
!
Power Supply Service Personnel should note that the power supply
contains double pole fusing.
Vorsicht
!
Wartungspersonal sollte beachten, daß die Spannungsquelle zweipolig
gesichert ist.
Remove the power supply unit from ModuSys 2000 kernel as follows (See
Figure 31):
1. Follow the instructions in Chapter 3 to dismount the module unit
from a rack if additional access is required
2. Disconnect the mains power cord from the rear of the enclosure.
3. Disengage the retaining lock (1) by pushing sideways and slide
out the PSU (2) from the enclosure.