Page 66
VIVO Monitor
VIVO Monitor
Sabotage Detection System (alarms)
The Vivo monitor has a tamper connector. The monitor generates an alarm tone and sends an alarm report
to the Property Management Station Alarm should anyone try to disconnect it.
Any type of sabotage must be detected and communicated to the Property Management Station (Guard
Unit) Alarm. Connection integrity must be guaranteed between the Sensor Module and the monitor and
between the monitor and the Property Management Station Alarm.
The integrity of the monitor is guaranteed by the tamper.
Communications between the monitor and the Sensor Module are regularly checked. The monitor
continuously checks the status of the Sensor Module and, in the event of failure, the monitor will send a
Sabotage Alarm to the Property Management Station.
Communications between the Property Management Station and the monitor are regularly controlled on
the monitors of the system in which the alarm is enabled. Should communications fail, an alarm message
is displayed at the Property Management Station.
2.15 LIFT CONTROL
The specifi c functions for Lift Control will be determined by the installation and confi guration
provided by the installer.
For security reasons, use of the lift by visitors and residents (tenants)
may require some kind of restriction in a system. The restriction level defi ned for residents
is different to that defi ned for visitors: visitors can only access the fl oor corresponding to
the home that opened the door to them, whereas residents can access their own fl oor and,
optionally, other ones (e.g. garage, gym, club, etc.), which would be the fl oors defi ned in
the
“
Group of Lifts
”
.
Lift Control from the Monitor.
On pressing the
Lift Control
icon, the lift is sent to the fl oor where the user lives (for a pre-
set period of time). Up to 3 relays can be activated when this icon is pressed (depends on
the installation/confi guration provided by the installer). The relay must be in the same Block
as the Monitor.
Lift Control from the Outdoor Panel for Visitors.
For security reasons, lift control will limit the destination of the lift for visitors who can only
access the fl oor corresponding to the home that opened the door to them
(for a pre-set
period of time).
For example: If a visitor calls Home 1402 located on Floor 14 from the Outdoor Panel and
its Tenant opens the door, the lift will only allow access to Floor 14.
Lift Control from Access Control Reader
Lift control can also be confi gured
through Access Control for
