Page 43
VIVO Monitor
VIVO Monitor
QUICK GUIDE: 1.2 Making Calls
Calls can be made to:
- Outdoor panels:
•
General Entries.
•
Panels from its block.
•
Panels associated to the home.
- Property Management Station = PMS (Guard Units).
- Another monitor installed in the same home.
- Another monitor in the same installation.
1.2.1 Call to Outdoor Panel
This screen displays:
- Private Home Entry Panels (1-line panels).
- Block Entry Panels
- General Entry Panels
- Access to IP cameras.
Note: The panels available are those that can call this home.
Users can select a panel and communicate with the panel, as seen in Point
1.1 Receiving
Calls
. At fi rst, only the video is connected. If required, users can connect the audio.
1.2.2 Calling the Property Management Station PMS (Guard unit)
This screen will display the
Name
of all the Property Management Stations (
name:
the
description defi ned in each one of them).
The Guard Units available are those that can call this home, if they are online and in a
Mode
other than OFF at the time of the call.
Users can select an PMS and a call is sent to it. The call ring tone is played. Once
the connection has been made
(answer from PMS)
, the monitor shows the operator
(concierge) of the PMS - if the PC has a camera fi tted - and a conversation can be held
with him/her.
1.2.3 Panic Call (SOS button)
The Panic Call is a special call for the Property Management Station (PMS) responsible for
receiving this type of call and the PMS must be confi gured as ALARMS. These calls take
priority over all others.
Note: For the SOS button to work, there must be a PMS ALARMS and this must be online and
in a Mode other than OFF at the time of the call. If not, there will not operate when the SOS
button is pressed.
There are three ways of activating the Panic Call in the Guard Unit:
1. Pressing the SOS button for 3 seconds.
SOS
SOS
2a) Silent Panic Alarm using the external secondary SOS button
. To delete the alarm
tone on the monitor, go to
Call Settings
and select the
Silent Panic Alarm
option.
3. Activating the alarm system.
If an alarm is detected, an alarm message is sent to the PMS
ALARMS with information on the sensors triggering the alarm.
2.
Pressing an external secondary SOS button
(a button that is directly connected to the monitor
(to panic terminals NG, P).
This is instant. The alarm tone is played for 1 minute on the monitor.
SOS
