Page 30
a) F1 transmitted by a phone
The residence terminals must have an F1 button to send the F1 command,
(for example, the
loft duox extra phone)
.
Upon pressing the F1 button on the phone, it sends the F1 command. The relay, if confi gured
this way, can be activated upon receiving the command.
5. From a street panel, make a call to the
last address in the range
. The last address should
be greater than the fi rst one. All leds should be off.
Note:
- To confi gure the fi rst and last addresses in the range to make the call from a push-button
panel, press the corresponding buttons for these addresses as indicated in steps 4 and
5. Remember that if the panel has a keypad, the call is made by entering the residence
the bell key.
Steps to DELETE the entered range.
1.
Press the
PRG
button twice, the
D
led should light up.
2.
Simultaneously press the
Sec/Single
and
Min/All
buttons. All leds should be off. The range
entered has been deleted.
Third step: Confi guration of the activation time.
To confi gure the activation time, follow point:
See:
2.4 CONFIGURING ACTIVATION TIME
VIA THE INTEGRATED BUTTONS (Sec/Single - Min/All).
2.5.2.5 ACTIVATING OR DEACTIVATING THE RELAY UPON RECEIVING AN ACTIVATE
F1 RELAY COMMAND
Function description.
You can confi gure the relay to activate or deactivate upon receiving the activate or deactivate
the F1
relay:
a) Transmitted by a phone or
b) Transmitted by a duox relay confi gured as explained in section:
2.5.1. TX Operating mode
section 2.3.1.4 ACTIVATION OR DEACTIVATION FUNCTION OF F1 RELAY.
TX
RX
3257
REF.
DISABLE
OUTPUT
12V 0.3A
SEC SINGLE
MIN ALL
OUT
NO
NC
C
RELAY
AV TRES CRUCES, 133
FERMAX ELECTRONICA, SAU
46017 VALENCIA - SPAIN
MADE IN SPAIN
BUS
OUTPUT
C
D
T
RX
PRG
MODULO RELE
DUOX
DUOX RELAY
MODULE
BUS INPUT
B
B
PRG
TX
B B
+12V
-
RESET/
SET
V
ON
3257
REF.
DISABLE
OUTPUT
12V 0.3A
SEC SINGLE
MIN ALL
OUT
NO
NC
C
RELAY
AV TRES CRUCES, 133
FERMAX ELECTRONICA, SAU
46017 VALENCIA - SPAIN
MADE IN SPAIN
BUS
OUTPUT
C
D
T
RX
PRG
MODULO RELE
DUOX
DUOX RELAY
MODULE
BUS INPUT
B
B
PRG
TX
B B
+12V
-
RESET/
SET
V
ON
DESTINATION
receptor relay
ORIGIN
transmitter relay
(confi gured as Activa-
tion or Deactivation
upon RECEIVING
an Activate F1 relay
command.
(the one being con-
fi gured as SEND of
the Activation or De-
activation command
on the F1 relay)
Relay confi gured
as SEND F1
Relay confi gured as acti-
vation/deactivation upon
RECEIVING F1
