Page 46
Notes:
- This confi guration screen only appears if the jumper is in TX position. If the jumper is
in RX when we perform step 4, the previous address of the remote relay (REMOTE
ADDRESS) is deleted.
- The activation or deactivation function of the remote relay is only executed if the remote
relay address is confi gured.
5. Via the arrows we select the
1.1 RELAY ADDR.
menu and press
Ok.
6. Via the number pad we enter the relay address we are confi guring, which must be between
0 and 999, and once entered press
Ok.
7. Via the arrows we select the
1.1 RELAY BLOCK
menu and press
Ok.
8. Via the number pad we enter the
relay block address
we are confi guring, which must
be between 0 and 99.
b) If you press the arrows (up/down) we confi gure the
relay
as
GENERAL ENTRANCE
.
To end press
Ok.
9. Upon turning the programmer off, the function remains activated.
Note: Upon activating the Set or Reset, the Relay Activation or Deactivation command is
sent to the confi gured Relay address and block. The origin address will be the same.
If you want to activate the Continued mode (TOGGLE).
1. Via the arrows we select the
1.3. TOGGLE MODE
menu and press
Ok.
2. Via the arrows we select
YES
or
NO
and press
OK
. If YES: the function is activated and
if NO: the function is deactivated.
3. Upon turning the programmer off, the function is confi gured.
Notes:
- The time and mode (timer/Continued), confi gured in the relay transmitter does not effect
the receptor relay.
- Local mode (transmitter relay - relay on):
* SET ON -> Activates relay.
* RESET ON -> Deactivates relay.
- Continued mode:
Remote Relay Activation:
* SET ON -> Activates remote relay.
* SET OFF
RESET ON
Remote Relay deactivation.
