Page 41
3.3.1.3 CALL GUARD UNIT FUNCTION
Function description.
You can install a button for calling the guard unit, and it can be installed far from the phone.
Via the terminal Set (button connected between the SET terminals and -), a call to guard unit
is made with the confi gured telephone´s original address, and with the confi gured guard unit
as destination.
Function confi guration.
1. Press the
On/Off
button, the display will show the
Duox Relay
and
version.
2. Via the arrows we select the
1. COMMAND
menu and press
Ok.
3. Via the arrows we select the
CALL TO GUARD
command and press
Ok.
4. Via the arrows we select the
2.GUARD UNIT
menu and press
Ok.
5. Via the arrows we select
ONE
and press
Ok.
6. With the arrows we select the type of
guard unit
we want to confi gure (Block or general
entrance guard unit) and press
Ok.
Note:
Depending on the type of guard unit selected, a different menu is displayed.
7. Via the number buttons we enter the
address
of the guard unit we want to confi gure and
press
Ok.
8. Via the arrows we select the
3. TERMINALS
menu and press
Ok.
9. Via the arrows we select
LIST
and press
Ok.
10. Via the arrows we select the
3.2. TERM LIST
menu and press
Ok.
11. Via the arrows we select
ADD
and press
Ok.
12. Via the number buttons we enter the
address
of the telephone we want to send the call
to the guard unit and press
Ok.
Note:
If you want to view the value entered for the address, select 3.2 TERM LIST and press
Ok. Via the arrows we select LIST and press Ok.
13. Upon turning the programmer off, the function remains activated.
Steps to change the guard unit assigned the function.
Carry out steps 4 to 7 of the previous process.
Steps to change the terminal assigned the function.
1. Via the arrows we select the
3.2. TERM LIST
menu and press
Ok.
2. Via the arrows we select
ERASE
and press
Ok.
3. With the arrows we go through the programmed terminals in the list and with the
Ok
we
can delete them. All terminals in the list must be deleted. Once all are deleted, press
ESC
.
4. Repeat steps 10 through 13 to program the new terminal (previous process).