![background image](http://html1.mh-extra.com/html/fbii/omni-400-eu/omni-400-eu_installation-and-setup-manual_547062073.webp)
Section 6. System Programming
6-37
QUESTION 13–18 ZONE REPORT CODES
L1 L2 L3 L4
1
st
digit
2
nd
digit
1
st
digit
2
nd
digit
zone “a”
zone “b”
Questions 13–18. Any zone with a reporting code other than AA will report to the CS. The first digit
is used for single-digit formats. For two-digit formats, both digits are used. For CID, the first digit is
used for the event code and the zone is the actual zone number. Refer to Section 8: Central Station
Reporting Formats for details on Contact ID reporting codes.
Use the separate Programming Form to enter the actual values for each zone’s report. For each of the
following questions, enter the digits as follows:
L1 and L2: Enter the first and second digits of the report code for the first zone (zone “a”) listed in the
question.
L3 and L4: Enter the first and second digits of the report code for the next zone (zone “b”) listed in the
question.
NOTE: If you are using 2-digit reporting and desire to send a report for zones 10–12, program A–C
respectively as the second digit of the report code.
L1
and
L2 L3
and
L4
L1
and
L2 L3
and
L4
Q 13
Zone 1
Zone 2
Q 16
Zone 7
Zone 8
Q 14
Zone 3
Zone 4
Q 17
Zone 9
Zone 10*
Q 15
Zone 5
Zone 6
Q 18
Zone 11
Zone 12*
* Questions 17 and 18 are not used in the OMNI-400 or OMNI-400EU. These questions apply to the
OMNI-600 and OMNI-600EU ONLY.
QUESTIONS 19–31 SYSTEM REPORT CODES
L1
L2
L3
L4
event “a”
event “b”
These questions enable the reporting of the event indicated on the EEPROM map if the value is not “A”
for single-digit events or “AA” for double-digit events. Selections can be 0–9, A–F. Refer to Section 8:
Central Station Reporting Formats for details on Contact ID reporting codes. Use the separate
Programming Form to enter the actual values for each zone.
For each of the following questions, enter the digits as follows (except as noted):
L1 and L2: Enter the first and second digits of the report code for the listed event.
L3 and L4: Enter the first and second digits of the report code for the listed event.