OMNI-400/OMNI-400EU and OMNI-600/OMNI-600EU Installation and Setup Guide
6-10
Movement Between and Within Questions
Random jumps to a specific question: Press the [
✱
] (star) button followed by the desired 2-digit
question number.
Example: To jump to question 07, press [
✱
] + [0] +[7]
Sequential to next question:
Press the [INSTANT] button
Accept data entry and move to
next data location in question:
Press [#]
Switch Submode:
Press [
✱
] + [BYPASS], then select submode from prompt
Data Entry
To alter the value in any location, enter the desired digit and press the [#] key.
The [#] key must be pressed after the entry of the desired digit. The system will not accept the
digit until the pound [#] key is pressed so that if a mistake was made, it can be changed.
Numeric values of 0–9 can be entered by pressing the respective keypad button. Entries of A–F require
2 keystrokes as follows:
Press the [CODE] button followed by 1
–
6 for values A
–
F.
VALUE KEYSTROKES
VALUE
KEYSTROKES
A
CODE 1
D
CODE 4
B
CODE 2
E
CODE 5
C
CODE 3
F
CODE 6
Example: To enter an A, press [CODE] followed by [1].
Exit System Program Mode
After all programming has been completed, press the [STAY] button to exit the system program mode.
Question Acknowledgment
The keypad will beep between keystrokes. In addition, a beep will be generated confirming
advancement between question numbers.
Four beeps will be generated if an invalid input is entered. Upon entry of an invalid input, you remain
at the same question number and location as prior to the input error.
To Enter Programming: [CODE] + [
✱
] + 4- or 6-digit Installer Code + [1] +submode 1–4
To Skip a Question: [
✱
] + 2-digit Question Number
To Move Within a Question: Press the [#] until the desired location is reached
To Enter Data: single digit: 0–9, A–F + [#]
Hexadecimal Entries:
A = [CODE] + [1]
D = [CODE] + [4]
B = [CODE] + [2]
E = [CODE] + [5]
C = [CODE] + [3]
F = [CODE] + [6]
To Exit Programming: Press the [STAY] button
