Section 6. System Programming
6-33
Code Trigger
Type
Description
1F
Shock Reset (*) Seconds
Momentary trigger for seconds when the [
✱
] key is pressed while disarmed.
20
CS Test Momentary Secs.
Momentary second trigger, when CS test transmits to CS.
21
Alarm/Restore
Goes on with alarm and off when all zones have met their restore
requirements.
22
2-Way Voice, On After
Seize Rel.
Works in conjunction with a two-way voice module. The trigger activates after
the dialer is done for the minutes programmed. The keypad sounders are
silenced until either bell cut-off or a valid user code is entered.
23
Momentary by Seconds
(soft)
May be activated by any soft key if programmed.
24
Momentary by Minutes
(soft)
May be activated by any soft key if programmed.
25
Toggle (soft)
May be activated by soft keys.
26
Follows Zn Loop, Trig=Zn 1-
10
For the first 10 zones only. The trigger offset is equal to the zone number.
Example: trigger 2 follows the normal/off normal state of zone 2.
27
Zone Alarm
Zones 1-10 = triggers 1-10. On with zone alarm, off when alarm memory is
cleared.
28
Zone Alarm/Restore
Zones 1-10 = triggers 1-10. On with zone alarm, off when restore for zone
occurs. This is based on Restore Follows Loop option. If Restore Follows Loop
is not enabled, restore occurs when the bell has timed out or upon disarm if the
zone is not violated.
29
Sys Bell, Internal, No Dings
Follows bell output but does not respond to bell test.
2A
Sys Bell, External
Follows bell output, but responds to bell test.
NOTE: In the above table, types 26 through 28 may be assigned only for relays and cannot be assigned
for triggers. Additionally, the relay number to which you assign the type correlates to a corresponding
zone number. For example:
a. If type 28 is assigned to relay 1, relay 1 is energized by an alarm condition on zone 1.
b. If type 28 is assigned to relay 3, relay 3 is energized by an alarm condition on zone 3.
Q 23 RELAY 1 and 2 TYPES
Q 26 RELAY 7 and 8 TYPES
Relay 1
Relay 2
Relay 7
Relay 8
Q 24 RELAY 3 and 4 TYPES
Q 27 RELAY 9 and 10 TYPES
Relay 3
Relay 4
Relay 9
Relay 10
Q 25 RELAY 5 and 6 TYPES
Q 28 TRIGGER 1 and 2 TYPES
Relay 5
Relay 6
Trigger 1
Trigger 2
Q 29 TRIGGER 3 and 4 TYPES
Trigger
3
Trigger
4
