![background image](http://html1.mh-extra.com/html/fbii/omni-400-eu/omni-400-eu_installation-and-setup-manual_547062031.webp)
Section 5. System Operation
5-11
QUICK ARMING: # 1
If programmed, Quick Arming will be permitted. Quick Arming allows arming the system without
entry of a user code. When you are using the ADEMCO Point ID reporting format, a PID code of 408
(closing, quick arm) with a user number of 128 is sent to the central station when the system is armed.
NOTE:
The system must be in Ready mode. A user code is required to disarm the system. Options
include:
[#] + [1]
Quick Arm the System in the AWAY mode
NOTE: If the user does not access an exit/entry zone during the exit
time and auto stay zones are programmed, the panel arms Auto Stay
and bypasses any zones programmed to do so.
[STAY] + [#] + [1]
Quick Arm the System in the STAY mode
[INSTANT] + [#] + [1]
Quick Arm the System in the INSTANT mode
[STAY] + [INSTANT] + [#] + [1]
Quick Arm the System in the STAY/INSTANT mode
QUICK FORCED ARMING: # 2
If programmed, then Quick Forced Arming will be permitted. Quick Forced Arming allows arming the
system without entry of a user code, and bypasses any bypassable zones that are not ready. When you
are using the ADEMCO Point ID reporting format, a PID code of 408 (closing, quick arm) with a user
number of 127 is sent to the central station when the system is armed.
NOTE: Bypassed zones include all of the individual points assigned to the zone. A user code is required
to disarm.
SET TIME: # 3
Pressing [#] [3] sets the time of the system clock. If a user code is required to set the time, then enter:
[#] + [3] + USER + HOUR + MONTH + DAY + YEAR
+ CRYSTAL ADJUST (optional) + ADJUST VALUE (optional)
where:
USER
Valid 4- or 6-digit user code
HOUR
Two-digit hour of day in 24 hour format; e.g., 7AM = 07; 3PM = 15
MINUTE
Two-digit minutes of hour; e.g., 9 min = 09; 29 min. = 29
MONTH
Two-digit month of year (01–12); e.g., Feb = 02; Oct = 10
DAY
Two-digit day of month (01–31)
YEAR
Two-digit year 00–99; e.g., 2010 = 10; 2000 = 00
CRYSTAL ADJUST
One-digit entry that is requested if using the Crystal RTC (enabled in
Submode 1, Question 10, Location 2). If the clock is keeping the correct
time, enter 1 followed by 00 for the adjust value. If the clock is not
keeping the correct time, enter 0 (Adjust up - Clock slow) or 1 (Adjust
down - Clock fast). For example, if the clock is showing 5:02 and the
actual time is 5:00, enter 1.
ADJUST VALUE
The number of seconds to be added to or subtracted from the RTC on a
daily basis. Note that the system only displays this prompt if the Crystal
RTC has been enabled (Submode 1, Question 10, Location 2). Valid