Fagor CNC 8070, Operating Manual

Page: 326 / 358

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡
Operating manual
CNC 8070
13.
SETUP ASSI
STANCE
The
ci
rc
ul
ar
it
y (
roundne
ss)
t
e
st
(S
OFT
V03.0
X
)
292
13.3.5 Data capture for the graphic
Once the graphic representation has been defined and the machine axes are being
interpolated, the point capture for the graphics may begin.
The point capture is initiated from the softkey menu. The point capture may be either
simple, where the graph is made once (a single whole circle), or continuous where
the graph is redrawn for every interpolation of the machine (after every whole circle).
The machine parameters may be modified while capturing points. See "Adjustment
of the machine parameters involved" on page 293.
Simple data capture
Data capture is initiated with the
SIMPLE
softkey. It deletes the graph and starts
drawing the circularity error enlarged to the defined scale.
The capture ends after a whole circle or when the
STOP
softkey is pressed.
Continuous point capture
Data capture is initiated with the
CONTINUOUS
softkey. It deletes the graph and
starts drawing the circularity error enlarged to the defined scale.
The capture ends when the
STOP
softkey is pressed.
When modifying the machine parameters, it is possible to see the new graph over
the previous one or press the
CLEAR
key to only see the new one.
Stop the point capture
Press the
STOP
softkey to stop the data capture. It stops the simple or continuous
data capture at any time.
Once the data capture is completed, two lines are drawn on the graph indicating the
angular position of the maximum and minimum error.
Delete the graphic representation
Use the
CLEAR
softkey to delete the graph. It deletes the graph and the data shown
over it.
It may be pressed at any time, even while it is being drawn.
When capturing points in the circularity test, they are not drawn on the
graphics of the CNC.
i
This softkey only stops the data capture. It does not stop the movement of the
axes. To stop the movement of the axes, press the [STOP] key of the operator
panel.
i