Chapter 4 Basic operations
57
8.
Press [At] again to set a fade rate for the cue assigned to the AB fader.
9.
Enter a fade rate from 0 to 99, or press [Full] (100 percent). A fade rate of
0 stops the fade. A fade rate of 100 is instant (no fade time). With fade
rate set at 50, cue runs at its recorded rate. If you do not enter a fade rate,
cue runs at its recorded rate.
10. Press [Enter] or [
➔
] to move the highlight to the next fader. You can use
any of the arrow keys to move around in the SMPTE edit display.
11. Repeat steps 4 through 9 for each fader to which you want to assign a
cue.
Hint: If you are creating a series of similar SMPTE events you may find it
helpful to use the PSC’s block editing feature. See page 59 for more
information on block editing.
12. Press [Time], enter the next desired SMPTE time and press [Enter]. Or,
press the down arrow key to add a new time one frame later than the
current time.
13. Repeat steps 4 through 11 for each SMPTE event you want to create.
14. Press [Reset] and enter the desired Reset time. This tells the
PSC when to
return to the first SMPTE event and restart the sequence.
15. Select any other display mode to leave SMPTE edit screen.
