Chapter 2 Hardware and installation
9
8.
Place a printed template sheet under the clear plastic flap on the digitizer.
9.
Set the voltage selection switch to match your electrical outlet
. In the US,
set the voltage switch to 110
.
10. Set the three sets of DIP switches on the digitizer as indicated in the chart
below.
Switch A
1
2
3
4
5
6
7
8
Off
Off
On
On
On
On
On
Off
Switch B
1
2
3
4
5
6
7
8
Off
On
Off
On
Off
Off
On
On
Switch C
1
2
3
4
5
6
7
8
On
On
Off
Off
Off
Off
On
Off
11. Turn on the
PSC, turn on the monitor(s), then turn digitizer power on by
pressing the on/off switch on the digitizer back panel
. The LED labeled
Indicator
is lit when power is on
. If the LED blinks four times after you
turn the power on, the interface cable is not connected correctly.
Note: It is very important that you turn the digitizer on only after first
turning on the PSC.
12. The
PSC displays the message
DWS ON
on the monitor when the
digitizer is properly installed and turned on.
Installing two monitors
You may want to install two monitors at the same time, one next to the
PSC
and one at a remote location. Install one monitor using the color video connector
and the other using the monochrome video connector.
The color monitor should be located next to the console because the color cable
is limited to a length of about 10 feet. The monochrome cable (RG59U) can be
as long as 150 feet. Therefore, use the monochrome monitor at the remote
location.
When you install both a monochrome and a color monitor, select monochrome
monitor from the System Settings menu as described on page 10.