Chapter 8 Reference
127
At
[At] indicates that the next number entered will be an intensity level for selected
channels. (You can also use the level control strip or [Full] to set intensity levels.)
1.
Select channels.
2.
Press [At] to indicate that the next number will be an intensity level
setting.
3.
Enter a two-digit intensity level setting for selected channels. Or, if you
prefer to enter levels on a scale of 1 to 10 (for example, 1 = 10 percent,
2 = 20 percent, etc.) enter a one-digit level and press [Enter].
Hint: It is not necessary to use [At] before pressing [Full] or before moving
the fader wheel.
When you are assigning cues to faders in SMPTE edit display, [At] allows you to
enter level and rate information for the cue loaded to the specified fader.
1.
Press [Edit SMPTE].
2.
Enter time of desired SMPTE event, then press [Enter].
3.
Press [Enter] until the desired fader is highlighted.
4.
Press [At], then enter level setting from 00 to 99, or press [Full].
5.
Press [At] again, then enter rate setting from 00 (stop fade) to Full (in-
stant). Entering a rate of 50 plays the cue at its recorded fade time.
6.
Press [Enter] to move to the next SMPTE event, or use the arrow keys to
move to another field.
Example
[At] [5] [0] or [At] [5] [Enter] sets selected channels at 50 percent.
[Edit SMPTE] [1] [0] [0] [0] [Enter] [Enter] [1] [At] [5] [5] assigns cue one in the AB
fader an output level of 55 percent and sets the rate at Full, or instantaneous.
