Ericsson SVP 2000, Reference Manual, Page: 42 / 196

Getting Started
Table 3.1 SVP 2000 Default IP Addresses
Ethernet Connector Default Address
Adaptor 0 192.168.1.1/255.255.255.0
Adaptor 1 192.168.2.1/255.255.255.0
Adaptor 2 192.168.3.1/255.255.255.0
Notes: Adaptor 2 has a fixed address so that the unit is always accessible. It can
be changed during a session of use but will revert to the default on a
repower cycle.
Adaptor 2 only allows control access, it should only be used to determine or
update the IP address configuration of Adaptor 0 and 1.
The control network and data networks should not conflict. It is suggested
that the ranges for these networks are in the Private-Use Networks as listed
in
Table 3.2 . IP Address range 192.168.10.x (subnet 255.255.255.0) is
used for internal unit communications, so should not be used for external
communications.
3.5 Applying the License to the SVP 2000
The SVP 2000 is by default delivered in a non-licensed state and requires
installation of the license to operate.
The license is installed via the web interface.
Figure 3.4 Initial License Page
Select the license via the Browse button, and upload the *.lic file associated with the
System UID.
EN/LZT 790 0046/1 R1A 3-8