Ericsson SVP 2000, Reference Manual, Page: 32 / 196

Installing the Equipment
2.5.1 AC Power Supply Cord
A mains supply cord is supplied with this product. It is fitted with a moulded plug
suitable for the region specified at the time of ordering. Please check that it is
suitable for the country in which the product is to be used.
2.5.2 Connecting the Equipment to the AC Power Supply
Connect the mains lead to the equipment and then to the local supply. Then switch
the unit on using the power switch on the front panel.
2.5.3 Protective Earth/Technical Earth
Warnings!
This equipment must be correctly earthed through the moulded plug supplied. If the
local mains supply does not have an earth conductor do not connect the equipment.
Contact Ericsson Customer Services for advice.
Before connecting the equipment to the supply, check the supply requirements in
Annex B, Technical Specification .
This equipment has a Technical Earth terminal located at the rear panel. Its use is
recommended but is
NOT a Protective earth for electric shock protection. The
terminal is provided for the following:

Ensures all equipment chassis fixed within a rack are at the same technical
earth potential. To do this, connect a wire between the technical earth terminal
and a suitable point on the rack.

Eliminates the migration of stray charges when connecting between equipment.
2.6 Rear Panel Signal Connectors
Signal connections are made via connectors on the rear panel. These are shown in
the following sections. Full technical specifications for the connections are given in
Annex B, Technical Specification .
2.6.1 SVP 2000 Encoder HD/SD SDI Interface
Standard and High Definition digital video can be input
via the two 75
Ω female BNC connectors at the rear
panel.
This interface is setup using the SDI Input Details
page under the
Advanced tab.
RX1 RX0
EN/LZT 790 0046/1 R1A 2-8