Ericsson SVP 2000, Reference Manual, Page: 30 / 196

Installing the Equipment
2.3.2.3 Protection from Moisture
Do not install this equipment in areas of high humidity or where there is a danger of
water ingress.
2.3.3 Installing Cables - Safety
Power supply cables should be routed so that they are not likely to be walked on or
pinched by items placed upon or against them. Pay particular attention to cables at
plugs, convenience receptacles, and the point where they exit from the appliance.
Warning!
Do not run AC power cables in the same duct as signal leads. Do not move or install
equipment whilst it is still attached to the mains supply. Ensure safety and ESD
precautions are observed while connecting equipment.
The signal cable types (or similar) described in the following table are those
recommended by Ericsson in order to maintain EMC compliance of the equipment.
Table 2.1 Cable Types
Signal Type Connector Cable
Ethernet (Control) RJ-45 CAT 5E Data Cable S-FTP
Ethernet (Data) RJ-45 CAT 5E Data Cable S-FTP
HD-SDI In (Digital Video
Input) BNC Belden 1694A
SDI In (Digital Video Input) BNC
Belden 1694A
Or
Canford Audio BBC 1/3 PSF (type 2
video cable)
2.4 EMC Compliance Statements
1
2.4.1 EN 55022/CISPR22
This is a Class A product. In a domestic environment this product may cause radio
interference in which case the User may be required to take adequate measures.
1
The EMC information was correct at the time of manufacture.
EN/LZT 790 0046/1 R1A 2-6