Ericsson SVP 2000, Reference Manual, Page: 38 / 196

Getting Started
3.2 Powering the SVP 2000 Video Processor
3.2.1 Before Powering Up
Before powering up the SVP 2000 Video Processor, check that:
1. The unit has been installed in a suitable location.
2. The unit has been connected to external equipment and power supply, as
required.
3. The power supply has been checked and a good earth provided.
3.2.2 Powering Up
The unit supply switch is located behind the front panel.
Figure 3.2 Items Behind the Front Panel
To power up the unit:
1. With all signal and power cables connected as required, turn on the unit using
the power switch. The SVP 2000 executes a series of power-up initialisation and
self-test routines.
Note: The boot time for the unit is approximately one minute.
2. Confirm that the green LED is lit showing that the unit is receiving power.
Caution!
This equipment should not be operated unless the cooling fans are working and
there is free-air flow around the unit.
EN/LZT 790 0046/1 R1A 3-4