Erbe ERBOTOM ICC 350 M, Instruction Manual

Page: 91 / 100

12-3
Error list
Error
No.
Error How to proceed?
0 No error
1 No HF output voltage Notify the Technical Service
2 HF output voltage too high Notify the Technical Service
3 No HF output voltage Notify the Technical Service
4 HF output voltage too high Notify the Technical Service
5 LF leakage current greater than 0.05 mA Notify the Technical Service
6 Activation error Notify the Technical Service
7 Activation error Notify the Technical Service
9 Time limit exceeded Heed maximum time limit
10 Erroneous setting of the AUTO CUT
function field during activation Before activation of a cutting mode, the AUTO CUT
function field must be completely set
11 Erroneous setting of the AUTO COAG 1
or AUTO COAG 2 function field during
activation Before activation, the AUTO COAG 1 or AUTO
COAG 2 function field must be completely set
12 Erroneous setting of the AUTO
BIPOLAR function field during
activation Before activation, the AUTO BIPOLAR function field
must be completely set
13 The contact surface between the neutral
electrode and the patient is too small or
the neutral electrode was not connected to
the unit.
This error is recognized and reported in
the Standby mode or during activation of
the unit.
Only for NESSY Version 2
Error in the connection between the
neutral electrode and unit
Only for NESSY Version 3
Short between the two contact surfaces of
a divided neutral electrode or in the cable
to the neutral electrode
Use a sufficiently large neutral electrode and apply to
the entire surface.
Check the connection of the neutral electrode to the
unit.
Check the connection between the neutral electrode
and unit. Probably a faulty cable or faulty plug
Eliminate short or exchange cable
17 HF leakage current greater than 300 mA Check whether the neutral electrode was correctly
applied and make certain that the patient has no
contact with electrically conductive objects.
18 HF leakage current greater than 150 mA Check whether the neutral electrode was correctly
applied and make certain that the patient has no
contact with electrically conductive objects.
19 The contact surface between the neutral
electrode and the patient was too small Use a sufficiently large neutral electrode and apply to
the entire surface.
20 The neutral electrode was applied in the
incorrect direction See Chapter 4.4.5
NESSY
21 The neutral electrode was applied in the
incorrect direction See Chapter 4.4.5
NESSY
22 When switching on the power switch, the
yellow pedal on the footswitch or the
yellow key on the electrode handle was
already pressed Check whether there was an operating error or
whether the yellow pedal of the footswitch or the
yellow key on the electrode handle is defective