EPSON Stylus Pro 10000/10000CF
Revision B
Troubleshooting
Troubleshooting Using the Messages
93
3.2.1 Warnings
Warning messages appear on the LCD display to warn users that a problem may occur. The
printer can still print and there is no effect on print quality; however the messages do not go
away until the possible problem is taken care of or the printer enters the corresponding error
condition. For example, the Waste Ink Pads Near Full message will remain until the pads
are replaced and the counter is reset or until the pads become full and the printer enters an
error state.
Table 3-4. Ink Low
Item
Description
LCD message
Ink Low
LED indicator
status
The LED indicator for the ink cartridge that is low flashes.
Explanation
The printer has received the Near-End signal from one of the ink low
sensors. After the LCD displays the Ink Low warning, the printer can print
about one A1 sheet at 100% duty. By all means, change the ink cartridge as
soon as possible.
Once a “low-ink” cartridge has been removed, it will automatically cause an
ink-end error if replaced in the printer.
Only replace empty or low cartridges with new, full cartridges; otherwise the
ink counter cannot perform correctly.
Recovery
Replace the old ink cartridge with a new one.
Table 3-5. Ink End
Item
Description
LCD message
INK OUT
LED indicator
status
Corresponded INK OUT LED blinks
Explanation
The printer detects ink end from an ink cartridge. It can print B0 (duty
100%) with sub tank ink cartridge just after this status, however, replace the
cartridge with a quite new one as soon as possible.
Recovery
Replace the ink cartridge with new one.
Table 3-6. Ink Cover Open
Item
Description
LCD message
CLOSE INK CART. COVER
LED indicator
status
All color ink cartridge LEDs go on.
Explanation
It is occurred when ink cartridge cover is open during printings.
Recovery
Close the ink cartridge cover.
Table 3-7. Maintenance Request
Item
Description
LCD message
"MAINTENANCE REQ. nnnn"
"nnnn": Refer to “Maintenance call” on page 101
LED indicator
status
Paper Out LED goes on for 100ms at intervals of 5 seconds.
Explanation
The life of the unit which designated by the code "nnnn" is almost run out. It
prompts user to call the service person to maintain it.
Recovery
Refer to “Maintenance call” on page 101.
Summary of Contents for Stylus Pro 10000 Series
