EPSON Stylus Pro 10000/10000CF
Revision B
Adjustment
Adjustment Steps
198
5.2.3.4 Cutter position adjustment
At the power off condition, prepares the A4 size or similar paper and ensure the cut action
carried out normally on the side of a starting point side and opposite side.
Gap between the blade and Sub_Platen should be 0.3 to 0.7 mm.
<Adjustment procedure>
1.
Select the "Test: Sensor" from the diagnostic mode and release the capping.
2.
Open the front cover and loosen the all Sub_Platen fixing screws. Then push it to
toward the bottom.
3.
At the starting point side, loosen the two of cutter holder screws then mount the L type
adjusting tool on the Sub_Platen. Fix the cutter holder position after the adjustment of
gap to the Sub_Platen.
4.
Attaching the adjustment tool from the right side and perform the adjustment with
Sub_Platen fixing screw.(6 Sub_Platens are presented.)
5.
Confirm the cutter operation by pressing the cutter cap several times.
6.
Shut the front cover and escape from "Test: Sensor" mode. (At this time place the
carriage in the middle of CR rail way.)
7.
Turn on the printer power and implement and confirm the paper cut operation.
Figure 5-5.
L Type adjusting tool
C A U T I O N
Do not take the up-and-down motion of the cutter in the place other
than the Sub_planten area.(It will cause cutter blade damage.)
Summary of Contents for Stylus Pro 10000 Series
