Epson Stylus Pro 10000 Series, Service Manual

Page: 282 / 323

EPSON Stylus Pro 10000/10000CF Revision A
Maintenance Maintenance inspection items 282
6.2 Maintenance inspection items
Do the inspection and necessary treatment at the time of the service enforcement about the
following item 1 - 8. About the ink leakage, wipe it once again with the cloth that dried after
the wipes it with the cloth etc. that wetted.
1. Remove the power cable from the plug socket after turns off the power supply and the
power supply lamp turn off, to carry out the inspection of the device department. Refer
to 4.2.1.4.
2. Remove the roll paper and the cloth for paper receiving.
3. Remove the following part in reference to Chapter 4.
n
Panel unit (Refer to 4.2.1.1)
n
Paper set lever (Refer to 4.2.1.2)
n
R side cover (Refer to 4.2.1.4)
n
L side cover (Refer to 4.2.1.5)
n
I/C holder cover (Refer to 4.2.1.6)
n
H top cover (Refer to 4.2.1.3)
n
Carriage cover (Refer to 4.2.3.3)
1.1 Ink supply tube : The presence of the damage and transformation of the ink tube and ink
leakage (trace is included) are confirmed. Wipe the ink leakage.
(1) Print head department : Remove 2 damper bracket mounting screw, and confirm
following items. (Refer to 4.2.3.3)
o
Is there ink leakage in the coupling part under the damper bracket?
Figure 6-5.
o
Is not the ink tube damaging in the damper bracket attachment department?
o
Is there ink leakage in the coupling part of the sub ink tank and stainless steel pipe
of the print head?
o
Is there ink leakage in the tube joint department and also periphery department
inside the print head?
Figure 6-6.
* Attach the nut and the O-ring once again after remove the nut and exchange the O-ring, in
the case that the ink leakage was discovered in the coupling department.
1. Ink tube relation
Coupling part