Epson Stylus Pro 10000 Series, Service Manual

Page: 41 / 323

EPSON Stylus Pro 10000/10000CF Revision B
Product Description Operating Panel Messages 41
1.5 Operating Panel Messages
Printer status and error messages appear on the operating Panel display. The table below
lists the messages.
Table 1-27. Operating Panel Messages
Display Message Meaning
SERVICE REQ. nnnnnnnn
Fatal error - see “Service Requests”
TURN PWR OFF AND ON
Turn the printer off and on to reinitialize
RESET In the process of re-initializing.
TRANSPORT PREP nn% See “Transportation Mode”
POWER OFF
Preparing to shut down.
COVER OPEN
The cover is open. The carriage stops in place, and the
printhead can be damaged if the head remains out of
the capped position for a long period of time.
SECURE PAPER LEVER
Paper Set lever is in the released and cannot continue
or begin a print, cleaning, or initialization sequence.
NO INK CARTRIDGE One or more cartridges are not installed
OPTION I/F ERROR
An unsupported Type-B interface card is installed.
INK OUT
• A predetermined amount of ink has been consumed
after the cartridge has entered the near-end
condition.
• A near-end cartridge has been removed and re-
installed.
READY *
Can receive and print data.
WAIT *
Resetting Timer IC
Clearing NVRAM
Performing reset operation
Performing ink sequence operation
Initializing the printer
Initializing the paper
INK CHARGING nnn%
Initial charging of ink - shown in percent completed
INK DRY xx MIN *
Printer waits xx minutes before the next print job to
allow enough time for ink to dry on previous print job.
PRESS PAUSE BUTTON Waiting for paper initialize start trigger
LOAD xxx PAPER
Wrong paper loaded or wrong paper source selected on
operating Panel.
LOAD PAPER
The Paper Set Lever is in the released position (before
printing). Pull the Paper Set lever forward to the set
position
PAPER JAM
Both front and rear paper sensors detect paper and
there is a carriage over-current or out of step error. This
is due to:
• Paper is jammed inside the printer
• Paper is obstructing the carriage path during feeding
or cutting operation.
PAPER NOT CUT
Printer did not cut the paper completely, or the cut
piece still remains over the paper sensor
PAPER NOT STRAIGHT
Paper skewed more than 3mm between the leading and
following edges. Check the printout for skew and make
sure no ink was fired onto the platen.
UNABLE TO PRINT
When trying to print a test or adjustment pattern, one of
the following occurs:
• Paper not loaded
• Ink cartridge not loaded
• Paper detection error
RELOAD PAPER
• The paper was loaded too far forward and cannot be
backward fed to the proper position.
• The paper’s horizontal position exceeds the normal
printable area when the paper is loaded.
• The paper’s horizontal position exceeds the normal
cutting area after printing.
• The cut sheet is too long and cannot be ejected
properly.
• Recovery from cutter error.
REMOVE PAPER Loaded paper is too thick to perform timer cleaning
PAUSE Pause state.
Table 1-27. Operating Panel Messages (continued)
Display Message Meaning