Epson Equity IIe, User Manual

Page: 162 / 276

5. Check to be sure the power button on the computer is off.
Then reconnect the power cable to the back of the
computer and to an electrical outlet.
Post-installation Setup for Memory Cards
After you install a memory card in your computer, you need to
configure your computer to use it. Follow these guidelines:
Use the Equity IIe’s Setup program to set the amount of
extended memory on your installed memory card. See
“Setting the Memory Configuration” in Chapter 2.
Use the setup program that comes with your memory card
to configure the computer for use with the installed memory
card. See your memory card manual for instructions.
If you installed an extended memory card and you want to
use it as expanded memory, use the EEMM286.SYS utility.
See “Using Memory Beyond 640KB” in Chapter 4 and your
MS-DOS Reference Manual for more information.
Also see “Post-installation Setup,” at the end of this chapter, for
more information on setting up your computer for use with an
option card.
To configure your computer for use with the RampagePlus® 286
memory card, you need to use CORFIX, an Epson utility on
your Reference diskette, and SMART, the RampagePlus 286
setup program. You must use CORFIX before you use SMART.
Follow these steps:
1. Make sure that the computer is on and that MS-DOS is
loaded. (See “Loading MS-DOS” in Chapter 4 for
instructions.)
5-22 Installing
Options